ML-1.5
Features
• Very high power and channel density
• Class - D Technology
• Power Factor Correction (PFC)
• Two-channel flexibility
• XLR input and output connectors
• AES/EBU Digital In/Out
• Ethernet Control
• powerCON In/Out
• Built in DSP
• Self protection design
• Efficient cooling system
• Comprehensive protection
Application
• Active Speaker
Specifications
Ratings (RMS @ 1% THD @ 230VAC)
| Model | ML-1.5 | |||
| Article No. | #10032 | |||
| Number of channels | 2 | |||
| Total output all channels driven | 1600 W @ 4 ohms | |||
| Max. Output Power | 4 ohms | 8 ohms | ||
| Per channel watts | 800 W | 400 W | ||
| Digital Signal Processor | ||||
| Input / Output | Analog | |||
| Frequency Response | 20Hz - 20kHz | |||
| Sample rate | 96kHz | |||
| PEQ | 6 parametric filters on each input / output | |||
| Delay | 60 ms delay on input / 20 ms delay on output | |||
| Crossover | Butterworth, Bessel, Linkwitz-riley filters up to 24dB / oct | |||
| Limiter | Each Input and Output | |||
| Phase | 180° | |||
| Latency | 600 micro seconds | |||
| Preset | 10 | |||
| PC Software | Available | |||
| THD+N (typical) | < 0.05 % (20 Hz - 20 kHz, 8 Ω load, 3 dB below rated power) | |||
| Signal To Noise-Ratio | > 120 dB (A-weighted, 20 Hz - 20 kHz, 8 Ω load) | |||
| Frequency Response |
20 Hz - 20 kHz ± 0.25 dB / 20 Hz - 20 kHz ± 0.15 dB (8 Ω load, 1 dB below rated power) |
|||
| Output Circuitry | Class D - full bandwith PWM modulator with ultra low distortion | |||
| Input impedance | 15 kΩ balanced | |||
| Damping Factor | > 2000 (8 Ω load, 1 kHz and below) | |||
| Gain and Level | ||||
| Amplifier gain selectable (Sensitivity) | -30dB to + 12dB | |||
| Level adjustment (per ch.) | Front-panel potentiometer | |||
| Connectors and Switches | ||||
| Input connectors | Neutrik® 3-pin XLR, AES/EBU, etherCON, powerCON | |||
| Output connectors | Neutrik® 3-pin XLR, AES/EBU, etherCON, powerCON | |||
| Front-panel indicators | ||||
| Per channel | Power | |||
| Safety | ||||
| Protection Circuits | Input limiter, short circuit protection, DC protection of output, under & over voltage protection, SOA protection, intelligent mains fuse protection, power stage overload protection, temperature protection of transformers and heat-sinks | |||
| Power | ||||
| Type | Universal & regulated switch mode power supply with Power Factor Correction (PFC) | |||
| Operating voltage | Universal Mains, 85-265V AC | |||
| Mains | Neutrik® powerCON | |||
| Finish | Black painted aluminum chassis | |||